TremGlaze SA1100 joint width, depth and movement limits
Measure the gap and check expected movement before setting the bead depth.
For TremGlaze SA1100, the minimum joint is 1/4 × 1/4 inch (6.4 × 6.4 mm). Keep depth equal to width for joints from 1/4 to 1/2 inch wide. At widths of 1/2 inch or greater, use a 1/2-inch depth. Movement must not exceed 12.5% of the minimum joint width.
Set the depth to suit the width
A 1/4-inch-wide joint takes a 1/4-inch sealant depth. A 3/8-inch-wide joint takes a 3/8-inch depth. For a 3/4-inch-wide joint, the specified depth stays at 1/2 inch.
Don't carry a general width-to-depth rule over from another sealant. SA1100's sheet calls for equal width and depth through the 1/4- to 1/2-inch range.
Check movement separately
The movement ceiling is 12.5% of the minimum joint width. Getting the bead dimensions right doesn't remove that limit.
Before ordering for a window perimeter, confirm the expected joint movement against that ceiling. If the project calls for more movement, ask for a sealant specified for that requirement.
Control depth before you fill the joint
Tremco prefers closed-cell polyethylene backer rod to control bead depth. Where the joint depth prevents using backing, the sheet calls for adhesive-backed polyethylene tape to prevent three-sided adhesion. The backing must be dry when you apply the sealant.
Make sure the joint surfaces are sound, clean and dry. Don't apply SA1100 to damp or contaminated surfaces. Fill the prepared joint completely, then tool immediately for contact with the joint faces. Dry tooling is preferred.
What the sheet doesn't settle
The supplied sheet gives a minimum joint size but doesn't state a maximum joint width or an application-temperature range. Its depth instruction for wider joints isn't approval for every gap size.
Check the TremGlaze SA1100 product details. If your joint falls outside the stated dimensions or its movement is uncertain, send Cranco the joint width, available depth, adjoining materials and expected movement before choosing the sealant.