How to clean up a paintable window joint

For TremGlaze SA1100, keep the joint dry, tool immediately and use soapy water for uncured cleanup.

For TremGlaze SA1100, clean up uncured sealant with soapy water. Tool the bead immediately after application using a dry tool. Keep those steps separate: Tremco prefers dry tooling, and the joint surfaces must be sound, clean and dry before you apply the sealant.

Already hardened? The SA1100 sheet gives no cured-sealant removal method. Don’t assume its soapy-water cleanup instruction covers cured material or a different paintable caulk.

Start with the joint surfaces

Check the frame and the adjoining surface before opening the cartridge. Tremco prohibits application to damp or contaminated surfaces. Dust, loose mortar, release agents, coatings and other surface conditions may call for wire brushing, sandblasting or solvent washing, depending on the substrate.

That isn’t a direction to use every cleaning method on every frame. If the finish or substrate leaves you unsure which preparation is suitable, get that settled before applying the bead.

Set the backing, then fill and tool

Tremco prefers closed-cell polyethylene backer rod to control bead depth. Where the joint is too shallow for backing, its sheet calls for adhesive-backed polyethylene tape to prevent three-sided adhesion. The backing must be dry when you apply the sealant.

Fill the joint completely, then tool immediately to press the sealant firmly against the joint surfaces. Dry tooling is preferred. Use soapy water for uncured cleanup, rather than treating it as the specified tooling method.

Paint timing has conditions

At 23.9°C and 50% relative humidity, TremGlaze SA1100 can be painted with latex or oil-based paint after 30 to 45 minutes. Keep those conditions with the timing when planning the work.

The sheet doesn’t give a paint-over time for a colder window opening or a different humidity level. It also doesn’t identify that 30-to-45-minute interval as full cure.

Check what’s in the cartridge

These instructions apply to TremGlaze SA1100, a siliconized acrylic latex sealant intended for general interior and exterior caulking, including window frame perimeters. Its joint movement limit is 12.5% of the minimum joint width.

Before buying, compare your joint and exposure with the TremGlaze SA1100 product details. If you need help settling preparation or cleanup, send Cranco the product name, frame material, adjoining surface and whether the unwanted sealant is still uncured.

Related guides