Window fillet bead contact area for Tremflex 834
Posted
Where to measure the contact, how to prepare the joint and when to ask for a project detail.
Check both surfaces before you size a Tremflex 834 window perimeter fillet bead. Tremco calls for at least 1/4 inch (6 mm) of contact onto each substrate, plus backer rod or bond breaker tape to provide release at the heel of the angle. Using another sealant? Check its sheet before carrying these dimensions over.
Measure onto each substrate
At a frame-to-surround corner, check two separate contact distances. At least 1/4 inch (6 mm) onto the frame. You also need at least 1/4 inch (6 mm) onto the adjoining surface, so measure along each surface and don't split one measurement between them. Here, 6 mm is a distance, not an area of 6 square millimetres.
Use backer rod or bond breaker tape at the heel of the inside angle, as Tremco specifies, to provide release. You need that release even when there's enough contact on both faces. Contact alone doesn't finish the detail.
Prepare the surfaces, then tool the bead
Get dust, loose mortar, laitance, release agents, existing waterproofing, paint and any other finishes off the surfaces before you lay a bead of Tremflex 834. Then check that they're sound, clean and dry. Any dampness or contamination? Don't apply it: Tremco says you mustn't use it in either condition.
For colder work, Tremco points you to its cold-weather sealant guide. Ready to apply the sealant? Check the surface temperature first: Tremco recommends at least 5°C during application.
With conventional caulking equipment, work from the bottom of the joint and fill it. Tool it immediately with a spatula so the sealant makes close contact with the joint walls. Keep the tooling dry where possible. If you need water, the sheet allows a limited amount on the spatula.
Don't stop at the 6 mm check
The contact dimension doesn't establish adhesion to your actual materials. Tremco recommends a mock-up or field adhesion test on the substrates being used.
Keep the fillet detail separate from the sheet's expansion-joint dimensions. Tremco gives expansion joints their own width and depth rules; the 6 mm contact requirement isn't a complete joint design.
Before ordering, compare the Tremflex 834 product details with your window detail. If the heel release or available contact surface is unclear, send Cranco the substrate names, joint dimensions and a photo or drawing. Ask Tremco Technical Services to confirm an unresolved application detail.